027 848 6778 | 0800 THUMPSTAR support@thumpstar.nz

Accessories

Genuine Thumptar accessories for your pit bikes. Check the videos below for full tutorial on installation and some tips.

Plastics Kits Information

for CRF50, KLX110, CRF110, TTR110 and DRZ110.

The after market CRF110 has two separate pieces of plastics.
*Radiator shrouds –
*Rear number plates or boards
*Front number boards or plates
*Rear mud guard –
*Front mud guard

Get the right Thumpstar plastic kit not the general aftermarket CRF110. There are also the CRF50 and CRF70. The former is smaller than the latter. CRF50 Measurements: Total height: 255mm; Total length: 440mm;
CRF70: Total Height: 295mm; Total length: 50cm

TKR110 and KLX/DRZ/KX65/RM65 – measurement: height from the bottom to the top: 240mm; total length: 325mm;

TDR110 plastics – fits LXR’s and other models. Total length: 48cm; height: 205mm

Step washers – are in al lthe Thumpstars. They stop the plastics from cracking and box from falling out. They don’t come with the plastic kits.

Fuel Caps Information

Measurements: same size based on the Honda CRF50 and some Suzukis and Kawasakis: Diameter is 52mm; thread can be different, added diameter is 48mm.
CNC Fuel cap – measurement: added diameter: 53mm; inner diameter of the thread: 48mm;
Breather – cutting it down to as short as possible. If it’s a shorter size, it could less likely to catch on your pants. Zip tie it as well. A blow test would determine if there’s a block, which will stop the bike from moving.
Fuel hose – goes inside the stem of the bike and locks in there.

Graphics Information

Information and Measurement of Graphics and Guide on How to Install Graphics to Plastics.

Dress Up Kits and Cam Covers Information

Information and Measurement Video